Trool Good Karma
Joined: 12 Sep 2003 Posts: 1486
|
Posted: Wed Feb 04, 2004 11:54 am Post subject: |
|
|
I don't know too much about this stuff, but i think, by looking from the datasheet, that this will work on some kinda bus. I think the basic idea is that u set this thing into some mode and then u can either read or write pins. If you look at page 7 of the datasheet it kinda tells u what each pin does...i only glanced at it, but i'll look into it in more detail and see if i can figure out what the datasheet is talking about...
But basicly this will involve building something around this so that u can easily send input to the pins u wana use and also read output from the same pins....how to go around doing that i think is the hard part....good luck.
BTW i might be totaly wrong about the whole thing so u might want to ask some ee or ece person...good luck _________________ The most exciting phrase to hear in science, the one that heralds new discoveries, isn't 'Eureka!' but rather 'hmm....that's funny.'
--Isaac Asimov |
|